PO Cavity analysis

─ 2.2. Meshing Parameters

In the PO module, the mesh generation is a required step that is performed immediately before simulating. In the Meshing Parameters window, represented in  Figure 11, the following options are available.

For this case is interesting to use the Regular Meshing option, in order to obtain a regular mesh of the geometry. As the simulation frequency is high, a good mesh will be obtained with edge size = 2.0 lambda. Figure 12 shows the mesh obtained.

 

Figure 11: Meshing parameters.


 

Figure 12: Mesh.
 

This example has been meshed in a personal computer by using 4 processors and requiring approximately 1.2 GB of RAM and 30 seconds to obtain a mesh of about 4.504 elements.

We use cookies on this website to improve your navigation experience on this site. By using this site, you agree to our cookie policy.

I agree