Observation directions are used when inspecting the generated results at the user interface, such as the generated Far Field results. This option is used for letting the user add, modify and delete these cuts. Select Output > Observation Directions to show the panel described in the figure:
In order to make the calculations useful, the user should configure observation directions where the electrical field will be calculated. These directions will be selectable by the user after the calculations have been done when inspecting the results. To add a cut, either a theta or a phi cut, press the Add button to add a row to the associated table, and fill the values in the row.
- Theta Cut / Phi Cut: this is the value at which theta will be fixed in a conical cut (theta cut) or at which phi will be fixed in a planar cut (phi cut).
- Initial Phi / Initial Theta: this is the initial value for the sweep in that observation direction cut.
- Increment: this is the value the angle will be incremented in each iteration for the sweep.
- Samples: the number of samples to take for the cut.
Final Phi / Final Theta is a non-editable value that will display the final angle for the sweep. This value is actually calculated using the following simple formula: Initial + Samples * Increment.
Rows can be deleted by selecting them in the tables and pressing Delete. Press the Save button when done.