Command Line 6.2.10

3.117. surfaceInterpolation command

Description: This command allows drawing a surface that goes through a set of points specified by the user.

Inline mode usage:

  • surfaceInterpolation -h: Displays the help file that summarizes the parameters for this command.
  • surfaceInterpolation–n <name> -p <u><v><x y z>: Draws a surface that passes through the points specified by the user, using interpolation.

Interactive mode usage:

  • Invocation: surfaceInterpolation
  • Parameters:
    • Number of points in u direction (default: 3).
    • Number of points in v direction (default: 3).
    • The points used for the interpolation. For each u coordinate, the user will be asked for the points corresponding to each v coordinate.


> surfaceInterpolation

Points in u direction [3]: 2

Points in v direction [3]: 3

Point [0][0] [x y z]: -1 -1 0

Point [0][1] [x y z]: -1 0 1

Point [0][2] [x y z]: -1 1 0

Point [1][0] [x y z]: 1 -1 0

Point [1][1] [x y z]: 1 0 1

Point [1][2] [x y z]: 1 1 0


Resulting surface using interpolation


We use cookies on this website to improve your navigation experience on this site. By using this site, you agree to our cookie policy.

I agree