Command Line 6.2.10

You are reading an old version of this user guide. The information contained here has been archived and is presented for reference reasons, but it may not be up to date.

3.124. threeDipoles command

Description: Add three dipoles to geometry.

Inline mode usage:

  • threeDipoles -h: Display a help message.
  • threeDipoles -n name -p x y z dipoleWidth centralDipoleHeight dipoleSeparation lateralDipoleHeight: Creates three dipoles.

Interactive mode usage:

The following steps will be needed in order to create new three dipoles:

  1. Central point [x y z]: Central point of the set of three dipoles.
  2. Dipole size [width height]: Size of the central dipole (width and height). The width will be the same for the lateral dipoles.
  3. Dipole separation [gap]: Separation between the central dipole and each of the lateral dipoles.
  4. Lateral dipoles height [height]: Height of the lateral dipoles.

Example:

threeDipoles example

threeDipoles example

 

We use cookies on this website to improve your navigation experience on this site. By using this site, you agree to our cookie policy.

I agree