GTD 6.2.9

8.1. Observation directions

When selecting this option (remember that it’s only active when the type of the simulation is Far Field), the following panel will appear:

 

 Observation directions panel

 

In this panel, we can specify the observation directions:

  • Sweep angle: the type of cut (phi cut or theta cut)
  • Cut:
    • Number of cuts: describes the number of cuts. It is an integer value.
    • Initial cut: defines the angular initial value (in degrees) of the cuts.
    • Final cut: defines the angular final value (in degrees) of the cuts.
  • Points:
    • Number of points: describes the number of points. It is an integer value.
    • Initial point: defines the angular initial value (in degrees) of the points.
    • Final point: defines the angular final value (in degrees) of the points.

 

 

We use cookies on this website to improve your navigation experience on this site. By using this site, you agree to our cookie policy.

I agree