In order to generate the geometry for the cell is recommended to pay attention the following considerations:
- For the cell construction the user geometries must be planar surfaces, located on XY planes (parallel to the floor) and centered over the 'Z' axis.
- If the user wants to locate a ground plane, a point where the ground plane will be located will be added. This point can be located in any order of the 'Z' axis but it will be considered as the bottom interface, i.e. the other interfaces must be located in upper orders of the 'Z' axis of this point.
- More points can be defined to generate empty interfaces but the reference plane only will be introduced on the bottom interface.
For information about the Geometry menu and the geometry primitives to add, refer to the GUI User Guide.