PO 6.2.11

8.1. Observation Directions

The user needs to configure the directions of observation where the electrical far field is to be calculated. The user selects a combination of angular sweeps in Theta or Phi, choosing in each case the number of samples for the variable angular component and the number of cuts to be simulated between the initial and final cuts, for the fixed angular value defined by the user. All the values for Theta and Phi are entered in degrees.  


Output Menu panel

 The following setting is available:

  • Cuts in Phi / Points in Theta: the user selects to compute cuts in Phi and angular sweeps in Theta.
  • Cuts in Theta / Points in Phi: the user selects to compute cuts in Theta and angular sweeps in Phi.
  • Number of cuts: defines the number of samples in the angular cuts where the user wants to compute the RCS
  • Initial Cut: define the cut initial value (in degrees).
  • Final Cut: define the cut final value (in degrees).
  • Number of Points: defines the number of samples in the angular sweep where the user wants to compute the RCS 
  • Initial Point: define the angular initial value (in degrees).
  • Final Point: define the angular final value (in degrees).

NOTICE: Press Save button before closing this window to confirm the changes.


We use cookies on this website to improve your navigation experience on this site. By using this site, you agree to our cookie policy.

I agree